Generic Questions

After the master-slave axes have been reference my slave axis no longer moves
Check in the macro.cnc that there is no homing command for the slave axis. In the example below, standard homing of X, Y, Z and A is performed: <...
Tue, 14 Dec, 2021 at 12:00 PM
How to run macro by using wireless pendant?
Pendant macro buttons "Macro-1" through "Macro-10" have their own macro . They call a macro subroutine from macro.cnc file. You can de...
Mon, 7 Feb, 2022 at 3:29 PM
Compensation values not shown in DRO
The Eding CNC has numerous ways of compensating mechanical offset, for example, pitch compensation or backlash. This is normally not shown in the DRO (Digit...
Tue, 1 Feb, 2022 at 5:01 PM
Motors switch on on software startup but switch off when "Reset" is pressed
Verify that the signal level for the 'Drive enable' output is correct. 'Drive enable' output may need to be inverted:
Mon, 7 Mar, 2022 at 9:37 AM
Tool in the machine does not match with tool number in the software - how to change the tool number without actual tool change
It is possible that at some stage, the physical tool that the machine currently uses does not correspond to the tool number in the software. This could be, ...
Mon, 16 May, 2022 at 10:19 AM
What are the system requirements to use EdingCNC?
Minimum requirement Recommended Processor Intel Core i3 / 1.4 GHz Intel Core i3 / 2.0 GHz or better Memory 4 GB RAM 8GB RAM or better Gra...
Mon, 14 Nov, 2022 at 4:48 PM
mfc140u.dll or MSVCP140.dll is missing
Please install Microsoft Visual C++ Redistributable: https://aka.ms/vs/17/release/vc_redist.x86.exe
Fri, 12 Aug, 2022 at 2:37 PM
Modulo operator result not as expected when using negative values
arithmetic modulo operat When negative values are involved in modulo operation, there are two methods of performing the calculation: the arithmetic method ...
Mon, 10 Oct, 2022 at 12:43 PM