Generic Questions
We consider a limit switch to be something else than a homing switch. Although this sounds logical it's important to understand the difference as we as ...
Mon, 6 Dec, 2021 at 9:12 AM
[FEEDSPEEDOVERRIDE] feedOverideSource = 1 adaptiveSpindlePowerFeedOv = 0 analogFeedOvAtMaxVoltage = 0.000 analogFeedOvAtMinVoltage = 0.000 analogStopOn...
Tue, 7 Dec, 2021 at 11:47 AM
The 0-10V signal is generated by using a PWM signal. Sometimes there are non linearities in the spindle speed or a different output range is required. The s...
Wed, 24 Nov, 2021 at 2:55 AM
Software version 5 Software version 5 does not support multiple profiles at this time. It is therefore recommended to install the software again in a diffe...
Fri, 20 Sep, 2024 at 8:57 AM
There can be a number of reason. Safety used in special case. Please check: - Is the machine homed ? This can be checked by looking at the DRO, ...
Wed, 24 Nov, 2021 at 3:03 AM
In some cases it turns out that the application 'Dell SupportAssist Remediation' is causing these buffer underruns. Try to disable this app...
Tue, 27 Oct, 2020 at 8:21 PM
Qstop means 'Quick Stop'. The machine is controlled stopped with the maximum deceleration that was indicated in the machine setup. Therefore, after ...
Wed, 24 Nov, 2021 at 2:57 AM
The starter software is missing the following functionality. No automatic tool change Macro starter Auto start after pause (cnc.ini) always off Z-up...
Mon, 15 Mar, 2021 at 10:47 PM
When the homing procedure has finished the machine will have moved a certain amount of distance from the home sensor so it is no longer activated. If you pr...
Tue, 14 Dec, 2021 at 11:50 AM
Check in the macro.cnc that there is no homing command for the slave axis. In the example below, standard homing of X, Y, Z and A is performed: <...
Tue, 14 Dec, 2021 at 12:00 PM